UMTS/HSPA Module Series
WCDMA UGxx AT Commands Manual
WCDMA_UGxx_AT_Commands_Manual Confidential / Released 89 / 247
Parameter
1. This command may be aborted generally by receiving an ATH command or a character during
execution. The aborting is not possible during some states of connection establishment such as
handshaking.
2. Parameter "I" and "i" only if no *# code is within the dial string.
3. See ATX command for setting result code and call monitoring parameters.
4. <n> is default value for last number that can be dialed by ATDL.
5. Responses returned after dialing with ATD.
For voice call two different responses mode can be determined. TA returns “OK” immediately either
after dialing was completed or after the call was established. The setting is controlled by AT+COLP.
Factory default is AT+COLP=0, which causes the TA to return “OK” immediately after dialing was
completed, otherwise TA will return “OK”, “BUSY”, “NO DIAL TONE”, or “NO CARRIER”.
6. Using ATD during an active voice call:
When a user originates a second voice call while there is already an active voice call, the first
call will be automatically put on hold.
The current states of all calls can be easily checked at any time by using the AT+CLCC
command.
Example
ATD10086; //Dialing out the party‟s number
OK
<n> String of dialing digits and optionally V.25ter modifiers
Dialing digits: 0-9, * , #, +, A, B, C
Following V.25ter modifiers are ignored: ,(comma), T, P, !, W, @
<mgsm> String of GSM modifiers:
I Actives CLIR (Disable presentation of own number to called party)
i Deactivates CLIR (Enable presentation of own number to called party)
G Activates closed user group invocation for this call only
g Deactivates closed user group invocation for this call only
<;> Only required to set up voice call, return to command state
To Next Page
Loading...
Need help?
General
