Autohelm
AutohelmAutohelm
Autohelm
SeaTalk Service Manual
4
3. Re-assembly
In all cases re-assembly is a reversal of the dismantling procedures above, but note;-
1. Ensure correct orientation of power amp PCB loom when reconnecting to the
computer PCB. Ensure a loom clip is fitted to the ribbon cable connector.
2. Ensure that insulating caps are all in place before sliding the power amp PCB back
into the extrusion. Ensure that the silpads are fitted between the transistors and the
extrusion.
3. Ensure that the correct transistor type is placed at each location. (Fig. 2).
4. Ensure that transistor/PCB securing screws are not loose, but do not over tighten.
To Next Page
Loading...
Need help?
General
