12 ST70+ User Reference Manual
1.6 Commissioning requirement
WARNING: Product installation & operation
ST70+ products must be prepared for use in accordance with the
Commissioning Procedures, before they are used for operational
purposes, unless they are part of a SeaTalk
ng
system in which at least one
other ST70+ display is already set up and working. Failure to comply with
this could result in death, personal injury, damage to your boat and/or poor
product performance.
After installation, each ST70+ display that is NOT part of a SeaTalk
ng
system in which
at least one other ST70+ display is already set up and working must be commissioned
in accordance with Chapter 2: Commissioning Procedures, before it is used for
operational purposes.
Refer to the ST70+ Operating Guide for instructions on how to use the ST70+
products on a day-to-day basis.
Autopilot calibration
The detailed requirement for autopilot calibration depends on the autopilot type. The
procedures given in this manual are those for a ‘typical’ Raymarine autopilot system.
If necessary adapt the procedures in this manual to suit your system. If you need
assistance, contact your Raymarine dealer.
85024_1.book Page 12 Tuesday, January 27, 2009 11:31 AM
To Next Page
Loading...
Need help?
General
