66 ST70+ User Reference Manual
About Pilot
If the display is set as a Pilot Controller, carry out the following check:
1. With the Diagnostics menu displayed, scroll to select the
About pilot
option, then
press
OK
, to display the
About pilot
page. This shows:
2. Note that:
•
Temperature
should be in the range -30°C
to +70
°C
•
Volts (CAN)
should be 12 V
•
Volts
should be in the range 9 V to 16 V
3. Make a note of any data you need then press
OK:
.
• If there is no more data to be displayed, the
display shows the
Diagnostics
menu.
• If there is more data to be displayed, the next page of
About Display
data is dis-
played. Repeat step 3 until the display shows the
Diagnostics
menu.
Product support
Raymarine provides a comprehensive customer support service, on the world wide
web and by telephone help line. Please use either of these facilities if you are unable
to rectify a problem.
World wide web
Please visit the Customer Support area of our web site at:
www.raymarine.com
As well as providing a comprehensive Frequently Asked Questions section and
servicing information, the web site gives e-mail access to the Raymarine Technical
Support Department and a details of the locations of Raymarine agents, worldwide.
Telephone help line
If you do not have access to the world wide web, please call our help line.
In the USA, call:
• +1 603 881 5200 extension 2444
In the UK, Europe the Middle East or the Far East, call:
• +44 (0) 23 9271 4713 (voice)
• +44 (0) 23 9266 1228 (fax)
• Time since power on. • Temperature
• NMEA manufacturer’s product code • Voltage
• Raymarine product description. • Peak voltage
• Raymarine product identity • Current
• Software Version Number • Peak current
• Hardware Version Number • Total hours run
• Bootloader Version Number
D11408-1
Press OK to continue
About Pilot
Run Time
Software Ver.
Bootloader Ver.
Hardware Ver.
Temperature
Volts (CAN)
Volts
V0.20
V2.00
V0.10
35.20 C
12.0 V
12.26 V
85.00
Up Time 3.50
85024_1.book Page 66 Tuesday, January 27, 2009 11:31 AM