Setting Up the Machine
This section explains how to enable encryption of transmitted data and configure the administrator account.
If you want higher security, make the following setting before using the machine.
1. Turn the machine on.
2. Press the [User Tools/Counter] key.
3. Press [System Settings] using [ ] or [ ], and then press the [OK] key.
4. Press [Interface Settings] using [ ] or [ ], and then press the [OK] key.
5. Select [Network] using [ ] or [ ], and then press the [OK] key.
6. Specify IP Address.
7. Connect the machine to the network.
8. Start Web Image Monitor, and then log on to the machine as the administrator.
9. Install the device certificate.
10. Enable secure sockets layer (SSL).
11. Enter the administrator's user name and password.
The administrator's default account (user name: "admin"; password: blank) is unencrypted between
steps 7 to 10. If acquired during this time, this account information could be used to gain unauthorized
access to the machine over the network.
If you consider this risky, we recommend that you specify a temporary administrator
password between steps 1 and 7.
1. Getting Started
14
To Next Page
Loading...
Need help?
General
