Cause Solution
The machine moves or the roll-up unit is not
aligned.
When the machine moves and work to make it level is
required, or when the roll-up unit is not correctly
aligned, contact your service representative.
The drying temperature is too high. Decrease the post-heater and cure-heater
temperatures.
If media floating cannot be resolved, contact your service representative.
When Media Skews While Feeding
Cause Solution
Media has not been set straight into the
media input location.
Reset the media correctly. For details about setting
media, see page 50 "Setting Media".
If using media without resetting it first, feed about 1 m
(approx. 39.37 inches) of the media from the [Origin
Setting] screen. If this does not eliminate skewing,
release the lock on the roll core holder, and move the
position of the roll core holder in the direction that the
media has been skewed.
The machine moves or the roll-up unit is not
aligned.
When the machine moves and work to make it level is
required, or when the roll-up unit is not correctly
aligned, contact your service representative.
When Media Is Not Fed Properly
197
To Next Page
Loading...
Need help?
General
