Changing Print Origin
This section explains how to change the position of the print origin.
You cannot change the origin when a misfeed error occurs or during maintenance.
• The carriage moves when setting the horizontal origin. A buzzer sounds after 10 minutes or more
have elapsed since the carriage moved. As a discharge defect may be caused by dry nozzles,
carry out the work promptly.
About the print origin
When entering origin setting mode, the LED pointer on the bottom of the carriage will indicate the
print origin. Check the position indicated by the pointer when changing the origin. When the
change is completed, the position set will be used as the reference point for printing.
1. Press [Origin Setting/Cut] on the bottom right of the screen.
2. Press [Left] or [Right] to change the horizontal origin.
The carriage will move in accordance with the latest numerical value. If the latest numerical value is
larger, hold down the button.
3. Press [Rewind] or [Feed] to change the vertical origin.
The media is fed in accordance with the latest numerical value. If the latest numerical value is
larger, hold down the button.
4. After the origin is fixed, press [Set].
The origin is changed, and the carriage will return back to its original position.
Changing Print Origin
79
To Next Page
Loading...
Need help?
General
