11. Perform [Nozzle Cleaning: High].
• If ink adheres on the internal components of the machine while removing jammed media, the back
side of media may get dirty. If the back side of media gets dirty after the jammed media is
removed, clean the platen. For details about cleaning, see "Cleaning the Platen", Requests for
Daily Care and Maintenance.
Removing Jammed Media in the Cutter Unit
Remove the jammed media in the cutter unit when the following message appears on the display:
"Check the cutter and then open and close the center cover."
1. Remove jammed media in the cutter unit.
2. Open the center cover on the front of the machine.
3. Close the center cover.
Clearing Misfeeds
231
To Next Page
Loading...
Need help?
General
