.1
74 / 93
8.3 QC-Flags
Nr. c111 Comment c111 Check
29
>R 2(2s)
<R 2(2s)
2-2SA (Syst.Error 1 -2 Results)
Description:
Two sequential control measurements are above 2SD or below -2SD, both on the same
side.
35 R 1(3s)
1-3SD (QC error 1)
Description:
One control value is above 3SD or below -3SD.
36 R 1(2.5s)
1-2.5SD (QC error 2)
Description:
One control value is above 2.5 SD or below -2.5 SD.
8.4 Derived Flags
Nr. c111 Comment c111 Check
43 Cal Error
Calibration Failure Data (Sample Flag)
Description
No calibration data or previous calibration data used.
CAL ERROR appears on each control and patient sample for the affected test until the
problem is resolved.
Caused by an alarm that occurred during calibration because the calibration could not
provide a usable result.
110
? Cal
Description
A result where its calibration is flagged
The calibration was in question and has been flagged, however the calibration could be
used to calculate the result (compare with CAL ERROR where the calibration did not
provide a usable result)
111
? QC
Description
A result where the quality control measurement is flagged
The last QC measurement before this measurement was flagged.
The dependency is derived from the time sequence.
112
Cal Due
Description
A result where the calibration is due but not yet executed (Regular mode only). The user
decided to delay the calibration measurement
To Next Page
Loading...
Need help?
General
