To Next Page

To Previous Page

4-78

FACSIMILE►OTHERS FUNCTION

SCANNING ORIGINALS

ERASING PERIPHERAL SHADOWS ON THE IMAGE

(ERASE)

This function erases the parts of the image where shadows tend to form, but does not detect shadows and erase only

the shadows.

Scanning a thick book

Erase modes

Shadows appear here

Not using the erase

function

Using the erase

function

Shadows appear in the image.

No shadows appear.

If a ratio setting is used in combination with an erase setting, the erase width will change according to the selected ratio. This

function erases the parts of the image where shadows tend to form, but does not detect shadows and erase only the

shadows.

For example, if you set an erase width of 1/2" (10 mm) and reduce the image to 70% before transmission, the erase width will

be reduced to 3/8" (7 mm).

To change the default erase width setting:

Select

[System Settings] → [Image Send Settings] → [Common Settings] → [Condition Settings]

→ [Erase Width

Adjustment].

The width can be set from 0" to 1" (0 mm to 20 mm). The factory default setting is 1/2" (10 mm). The setting changed here will

apply to [

System Settings

] → [Copy Settings] → [Condition Settings] → [Erase Width Adjustment] in "Settings".

Place the original.

Place the original in the document feeder tray of the automatic document feeder, or on the document glass.

► AUTOMATIC DOCUMENT FEEDER (page 1-75)

► DOCUMENT GLASS (page 1-77)

Edge Erase Center Erase Edge + Center Erase Side Erase

Sharp MX-B455W User Manual

Other manuals for Sharp MX-B455W