7-176
SYSTEM SETTINGSâ–ºSETTING MODE FOR FAX
Activity Report Print Select Setting
You can set the machine to periodically print the activity report that is stored in memory.
The Image Sending Activity Report can be set to print each time the number of transactions reaches 200, or at a specified
time (once a day only). (The settings can be simultaneously enabled.)
ECM
When you send a fax, noise on the line may occasionally cause distortion of the image. You can enable ECM (Error
Correction Mode) to automatically resend only the part of the image that was distorted.
Digital Line Network
When this setting is enabled, the send level will be 15 dB or less when you connect to a digital line.
Distinctive Ring Detection
If multiple telephone numbers have been assigned to your telephone line, the number called can be identified by its
ringing pattern. By using one number for voice calls and another number for faxes, you can tell which type of call you are
receiving by the ringing pattern. You can set your machine to automatically receive faxes when your fax number is called
by setting the pattern that corresponds to your fax number.
Send Settings
Settings for fax transmission can be configured.
Auto Reduction Sending Setting
This setting is used to have the size of transmitted faxes automatically reduced to match the size of the paper in the
receiving machine.
If the setting is disabled, faxes are sent at full size. Because the size is not adjusted to match the size of the printing
paper, part of the received fax may be cut off.
Rotation Sending Setting
When transmitting an image that is one of the following sizes, this function rotates the image 90 degrees
counterclockwise. (The setting can be configured separately for each size.)
5-1/2" x 8-1/2", B5, A5
Quick On Line Sending
When this setting is enabled, the machine starts transmitting a fax as soon as the first page is scanned.
Transmission takes place at the same time as the remaining pages are being scanned.
Printing Page Number at Receiver
When the transmitted image is printed by the receiving machine, the page number can be added to the top of each
printed page.
Sender Destination Name Switch
Allows you to change the destination name and sender fax number if necessary.
• If you only select the "Print Daily at Designated Time" setting and the number of recorded transactions reaches 200
before the specified time, each new transaction will delete the oldest transaction (the oldest transaction will not be printed).
• The Transaction Report can be printed out manually as needed. For more information, see "List for Administrator (page
7-53)".
If the receiving machine is a Super G3 machine, ECM will always operate, regardless of this setting.
To Next Page
Loading...
Need help?
General
