6-26
DOCUMENT FILINGâ–ºUSING STORED FILES
FILE TRANSMISSION
The settings used when the file was stored with document filing are stored, and thus the file can be transmitted using
those settings. If needed, you can also change the transmission settings to modify the retrieved file.
After selecting the desired file, follow the steps below.
â–º SELECTING A FILE TO RETRIEVE (page 6-22)
8
Tap the [Start] key to start printing.
If there are no files that match the search conditions, you will return to the file list screen.
It [Delete the Data] on the action panel is tapped, all files that match the current search conditions will be deleted.
• A file saved in black and white or grayscale cannot be transmitted in color.
• A stored print job cannot be transmitted.
• These transmission methods require installation of the corresponding options.
• If any of the following other modes were included in the saved file, the file cannot be transmitted.
"Stamp", "Photo Repeat" for copying.
• If any of the following other modes were included in the saved file, the file can be transmitted, but other functions cannot be
executed.
"Margin Shift", "Transparency Inserts", "Stamp", "Centering"
• Depending on the reduction or enlargement ratio used when storing a file, it may not be possible to send the stored file
using a selected resolution setting. In this event, try changing the resolution.
However, when sending a stored file by Internet fax, transmission may not be possible even if the resolution is changed.
• Files saved in other than Internet Fax mode cannot be sent to an Internet Fax address.
1
Tap [Send] on the action panel.
2
Select settings for sending.
3
Tap the [Start] key.
To Next Page
Loading...
Need help?
General
