500-8067.9 * INSTALLATION AND OPERATING INSTRUCTIONS 8DJH * Revision 03 95
Installation
13.3 Connecting secondary equipment
The terminal strips of the secondary equipment supplied are assigned to the associated
operating mechanisms/feeders. For external connection you will require the circuit
diagrams supplied.
Fig. 68: 8DJH: Operating mechanism box of ring-main panel
a
Wiring duct
s
Ready-for-service indicator
d
Ter m in al strip
f
Customer-side wiring
Fig. 69: Wire routing for switchgear
without wiring duct
Fig. 70: Wire routing for switchgear
with wiring duct a
Recommended wire routing for secondary equipment: from the side, from the rear and from above. For access from below, use screened cable plugs.
Wire routing for panel blocks possible through wiring duct. For extendable switchgear, wire routing through the wiring duct is recommended.
To Next Page
Loading...
Need help?
General
