Parameterizing the Mobile Panel
5.11 Enabling NTP
Mobile Panels 2nd Generation
Operating Instructions, 09/2018, A5E33876626-AC
127
The device name must be unique and satisfy the DNS conventions within the local
network. These include:
– Restriction to 127 characters (letters, digits, hyphen or point)
– A name component within the device name, for example, a string between two points,
may not exceed 63 characters.
– Special characters such as umlauts, brackets, underscores, slashes, spaces, etc. are
not permitted.
– The device name must not start or end with the "-" character.
– The device name must not take the form n.n.n.n (n = 0 to 999).
– The device name must not start with the character string "port-xyz-" (x, y, z = 0 to 9).
4. Confirm your entries.
The dialog closes.
5. Restart the HMI device, see section "Restarting the HMI device (Page 101)".
To obtain the time of the HMI device from a time server, you can specify up to four different
time servers. The time is synchronized using the "Network Time Protocol". The
synchronization cycle applies to all configured time servers.
● The HMI device and time server are located in the same network.
● The Control Panel is open.
To Next Page
Loading...
Need help?
General
