Mobile Panels 2nd Generation
Operating Instructions, 09/2018, A5E33876626-AC
189
Overview
Configuration phase
A project – the process image of the working process – is produced during configuration to
visualize automated working processes. The process displays for the project contain
displays for values and messages which provide information about process statuses. The
process control phase follows the configuration phase.
The project must be transferred to the HMI device if it is to be used in process control.
Another requirement for process control is that the HMI device is connected online to a
controller. Current working processes - operating and observing - can then be subject to
process control.
Commissioning and recommissioning
Initial and re-start-ups differ in the following respects:
● When the HMI device is commissioned there is no project at first.
The HMI device is also in this state after the operating system has been updated.
● When recommissioning, any project already on the HMI device is replaced.
The HMI device may be in the following operating modes:
● Offline
● Online
● Transfer
"Offline mode" and "Online mode" can be set on both the configuration PC and the HMI
device if a corresponding operating element has been configured.
In this mode, there is no communication between the HMI device and PLC. Although the
HMI device can be operated, it cannot exchange data with the PLC.
To Next Page
Loading...
Need help?
General
