Description
1.8 Safety information
SIMOTION D410-2
24 Manual, 02/2012
1.8 Safety information
Observe the following safety information when working with SIMOTION D410-2 and its
components!
CAUTION
The CompactFlash card may only be unplugged and plugged in when SIMOTION D410-2
is switched off (zero current)!
The SIMOTION D410-2 is in a de-energized state when all the LEDs are OFF.
The CompactFlash card is an ESD-sensitive component. When removing and inserting the
CompactFlash card, observe the ESD regulations.
CAUTION
The 50 mm clearances above and below the components must be observed. The
ventilation openings at the top and bottom must not be covered by any connecting cables.
WARNING
Safe, problem-free operation of the SIMOTION D control unit assumes proper
transportation, storage, setup, and installation, as well as careful operation and
maintenance.
In addition to the danger and warning information provided in the technical customer
documentation, the applicable national, local, and plant-specific regulations and
requirements must be taken into account.
Only safety extra-low voltage in accordance with EN/IEC 60950-1 may be connected to all
connections and terminals.
To Next Page
Loading...
Need help?
General
