7 - 43
7 Transmission Repair
7C Hydro-Gear 216-3010L
17. Apply pressure onto the outer end of each bearing
retainer to compress the wave washer and install the
complete assembly into the pockets of the housing
while aligning the notches in the bearing retainers
with the tabs in the housing. The offset of the input
shaft in the bearing retainers should be towards out-
side as shown in Figure C-29.
Figure C-29. Install Input Assembly
18. Position the right hand housing assembly and apply
the liquid gasket onto the housing face. A small bead
of the sealant around the outer part of the housing
face will be sufficient.
Note: Prior to applying new sealant, the old sealant
must be cleaned from all surfaces
Note: A small recess on the right hand housing face is
designed to catch a limited amount of sealant as it
is squeezed out from between the housings dur-
ing assembly. This area improves the sealing of
the housing but, excessive sealant could contami-
nate the transaxle assembly. Use sparingly.
Figure C-30. Sealant Application (RH Housing)
Bearing retainer offset
toward outside
To Next Page
Loading...
Need help?
General
