4 - 7
4 Adjustments
Clutch/Brake Adjustment
Figure 9. Brake Rod Spring Adjustment -Tuff Torq
Hydro
A. Nut
CLUTCH/BRAKE ADJUSTMENT
Tuff Torq K215A
1. Engage the parking brake.
2. The spring should be compressed to 1-1/2" to
1-5/8" long. Turn adjustment nut (A, Figure 9) as nec-
essary for correct spring length.
*2272
Hydro-Gear 216-3010L
1. The brake was factory set for a specific running clear-
ance between the disc and pucks of 0.020".
2. Place a feeler gauge between the disc and one puck.
If the clearance is not properly set, remove the cotter
pin retaining the castle nut and set the correct clear-
ance by adjusting the nut. Reinstall the cotter pin.
Figure 10. Brake Adjustment
A. Feeler Gauge
B. Adjustment Nut
A
B
3. Fully depress the clutch/brake pedal and lock the
parking brake by pulling up on the parking brake
knob.
4. See Figure 11. The brake rod spring (A) should mea-
sure 3" (+-1/8”) when compressed. Turn the adjust-
ment nut (B) as necessary to obtain correct spring
length.
Figure 11. Brake Rod Spring Adjustment - Hydro-
Gear 3010L
A. Brake Rod Spring B. Adjustment Nut
A
B
To Next Page
Loading...
Need help?
General
