7 - 62
7 Transmission Repair
7E Tuff Torq K210A
3. Remove four capscrews holding brake cover to case.
4. Remove retaining ring, and brake drum from shaft.
5. Remove retaining ring, brake lining, and return
spring. Check the brake cam lever for free move-
ment.
Figure E-9. Remove Brake Cover
6. Drive the roll pin from the interlock lever, and remove
interlock lever from shaft.
7. Remove fourteen capscrews holding transaxle case
halves together.
8. Carefully pry the case halves apart using t pry points.
NOTE: The case was silicone sealed at the factory and
will not separate easily. Do not damage case by applying
excess pressure at pry point.
NOTE: When separating case halves, do not lose differ-
ential case washer, or bearing shim set on side of reduc-
tion shaft.
Figure E-10. Disassemble Brake Shoes
Figure E-11. Remove Interlock Lever
To Next Page
Loading...
Need help?
General
