6-23
6 General Repair
6B Hand Controls Repair
Figure B–14. Gear Shift Rod
Parts List
A. 5/16-18 x 1-1/2 Hex Capscrew
B. 5/16 Plain Washer
C. Shift Lever Assembly
D. Spacer
E. 5/16 Lockwasher
F. 5/16-18 Full Hex Nut
G. Shift Rod
H. Cotter Pin
I. 1/2 Plain Washer
A
B
C
B
D
B
E
F
G
H
I
TUFF TORQ K210A GEAR MODELS
1. Remove battery from unit to provide access to front
shift lever rod assembly at base of shift lever assem-
bly
2. Remove cotter pin that secures front shift lever rod to
shift lever arm, and set washers aside for reuse when
reassembling rod.
3. Safely elevate and support unit (See Elevating Unit
for Safe Service) and remove the mower deck for ac-
cess to transmission shift lever area.
4. See Figure B–14. Remove capscrew, hex nut, wash-
ers and spacers connecting shift rod to shift lever,
and remove shift rod from unit. Inspect shift rod for
wear or damage, and replace as required.
5. Reassemble parts in reverse order of disassembly,
applying grease to pivot points as indicated.
6. Adjust transmission as required for proper operation -
see "Adjustments" section of for specific procedures.
Shift Rod Service Cont.