S
YSTEM
M
ANAGEMENT
C
OMMANDS
3-33
Command Usage
• This switch provides more efficient throughput for large
sequential data transfers by supporting jumbo frames up to
9000 bytes. Compared to standard Ethernet frames that run only
up to 1.5 KB, using jumbo frames significantly reduces the
per-packet overhead required to process protocol
encapsulation fields.
• To use jumbo frames, both the source and destination end
nodes (such as a computer or server) must support this feature.
Also, when the connection is operating at full duplex, all
switches in the network between the two end nodes must be
able to accept the extended frame size. And for half-duplex
connections, all devices in the collision domain would need to
support jumbo frames.
• Enabling jumbo frames will limit the maximum threshold for
broadcast storm control to 64 packets per second. (See the
“broadcast” command on page 3-100.)
Example
ip http port
Use this command to specify the TCP port number used by the
Web browser interface. Use the no form to use the default port.
Syntax
ip http port port-number
no ip http port
port-number - The TCP port to be used by the browser
interface. (Range: 1-65535)
Default Setting
80
Console(config)#jumbo frame
Console(config)#
b_mgmt.book Page 33 Tuesday, July 8, 2003 5:24 PM
To Next Page
Loading...
Need help?
General
