SMC Networks SMC EZ Switch 10/100/1000 SMCGS8P-Smart User Manual

C OMMAND L INE I NTERFACE
3-144
garp timer
Use this command to set the values for the join, leave and leaveall
timers. Use the no form to restore the timers’ default values.
Syntax
garp timer {join | leave | leaveall} timer_value
no garp timer {join | leave | leaveall}
•{join | leave | leaveall} - Which timer to set.
• timer_value - Value of timer.
Ranges:
join: 20-1000 centiseconds
leave: 60-3000 centiseconds
leaveall: 500-18000 centiseconds
Default Setting
• join: 20 centiseconds
• leave: 60 centiseconds
• leaveall: 1000 centiseconds
Command Mode
Interface Configuration (Ethernet, Port Channel)
Command Usage
• Group Address Registration Protocol is used by GVRP and
GMRP to register or deregister client attributes for client services
within a bridged LAN. The default values for the GARP timers
are independent of the media access method or data rate. These
values should not be changed unless you are experiencing
difficulties with GMRP or GVRP registration/deregistration.
• Timer values are applied to GVRP for all the ports on all VLANs.
• Timer values must meet the following restrictions:
leave >= (2 x join)
leaveall > leave
b_mgmt.book Page 144 Tuesday, July 8, 2003 5:24 PM

SMC Networks SMC EZ Switch 10/100/1000 SMCGS8P-Smart Specifications

General

Brand	SMC Networks
Model	SMC EZ Switch 10/100/1000 SMCGS8P-Smart
Category	Switch
Language	English