C
OMMAND
L
INE
I
NTERFACE
3-90
Example
To specify 57600 bps, enter this command:
stopbits
Use this command to set the number of the stop bits transmitted
per byte. Use the no form to restore the default setting.
Syntax
stopbits {1 | 2}
• 1 - One stop bit
• 2 - Two stop bits
Default Setting
1 stop bit
Command Mode
Line Configuration
Example
To specify 2 stop bits, enter this command:
show line
Use this command to display the terminal line's parameters.
Syntax
show line [console | vty]
• console - Console terminal line.
• vty - Virtual terminal for remote console access.
Console(config-line)#speed 57600
Console(config-line)#
Console(config-line)#stopbits 2
Console(config-line)#
b_mgmt.book Page 90 Tuesday, July 8, 2003 5:24 PM
To Next Page
Loading...
Need help?
General
