P
RIORITY
C
OMMANDS
3-167
Default Setting
Disabled
Command Mode
Global Configuration
Command Usage
• The precedence for priority mapping is IP Precedence or IP
DSCP, and default switchport priority.
• IP Precedence and IP DSCP cannot both be enabled. Enabling
one of these priority types will automatically disable the other
type.
Example
The following example shows how to enable IP precedence
mapping globally:
map ip precedence (Interface Configuration)
Use this command to set IP precedence priority (i.e., IP Type of
Service priority). Use the no form to restore the default table.
Syntax
map ip precedence ip-precedence-value cos cos-value
no map ip precedence
• precedence-value - 3-bit precedence value. (Range: 0-7)
• cos-value - Class-of-Service value (Range: 0-7)
Console(config)#map ip precedence
Console(config)#
b_mgmt.book Page 167 Tuesday, July 8, 2003 5:24 PM
To Next Page
Loading...
Need help?
General
