SMC Networks SMC EZ Switch 10/100/1000 SMCGS8P-Smart User Manual

I NTERFACE C OMMANDS
3-97
Default Setting
• 100BASE-TX: 10half, 10full, 100half, 100full
• 1000BASE-T: 10half, 10full, 100half, 100full, 1000full
• 1000BASE-SX/LX/LH: 1000full
Command Mode
Interface Configuration (Ethernet, Port Channel)
Command Usage
When auto-negotiation is enabled with the negotiation
command, the switch will negotiate the best settings for a link
based on the capabilites command. When auto-negotiation is
disabled, you must manually specify the link attributes with the
speed-duplex and flowcontrol commands.
Example
The following example configures Ethernet port 5 capabilities to
100half, 100full and flow control.
flowcontrol
Use this command to enable flow control. Use the no form to
disable flow control.
Syntax
flowcontrol
no flowcontrol
Default Setting
Flow control enabled
Console(config)#interface ethernet 1/5
Console(config-if)#capabilities 100half
Console(config-if)#capabilities 100full
Console(config-if)#capabilities flowcontrol
Console(config-if)#
b_mgmt.book Page 97 Tuesday, July 8, 2003 5:24 PM

SMC Networks SMC EZ Switch 10/100/1000 SMCGS8P-Smart Specifications

General

Brand	SMC Networks
Model	SMC EZ Switch 10/100/1000 SMCGS8P-Smart
Category	Switch
Language	English