SMC Networks SMC EZ Switch 10/100/1000 SMCGS8P-Smart User Manual

C OMMAND L INE I NTERFACE
3-96
Example
The following example configures port 11 to use autonegotiation.
Related Commands
capabilities (3-96)
speed-duplex (3-94)
capabilities
Use this command to advertise the port capabilities of a given
interface during autonegotiation. Use the no form with parameters
to remove an advertised capability, or the no form without
parameters to restore the default values.
Syntax
capabilities {1000full | 100full | 100half | 10full | 10half
| flowcontrol | symmetric}
no port-capabilities [1000full | 100full | 100half | 10full |
10half | flowcontrol | symmetric]
• 1000full - Supports 1000 Mbps full-duplex operation
• 100full - Supports 100 Mbps full-duplex operation
• 100half - Supports 100 Mbps half-duplex operation
• 10full - Supports 10 Mbps full-duplex operation
• 10half - Supports 10 Mbps half-duplex operation
• flowcontrol - Supports flow control
• symmetric (Gigabit only) - When specified, the port
transmits and receives pause frames; when not specified, the
port will auto-negotiate to determine the sender and receiver
for asymmetric pause frames. (The current switch ASIC only
supports symmetric pause frames.)
Console(config)#interface ethernet 1/11
Console(config-if)#negotiation
Console(config-if)#
b_mgmt.book Page 96 Tuesday, July 8, 2003 5:24 PM

SMC Networks SMC EZ Switch 10/100/1000 SMCGS8P-Smart Specifications

General

Ports	8
Port Type	10/100/1000 Mbps
Switching Capacity	16 Gbps
Forwarding Rate	11.9 Mpps
MAC Address Table Size	8K
Power over Ethernet (PoE)	Yes
Input Voltage	100-240VAC
Form Factor	Desktop/Rackmount
Features	VLAN, QoS, IGMP Snooping
Dimensions	280 x 180 x 44 mm
Operating Temperature	0°C to 40°C
Storage Temperature	-20°C to 70°C
Humidity	10% to 90% (non-condensing)
Jumbo Frame Support	Yes (9K bytes)

Summary

LIMITED WARRANTY

Limited Warranty Statement

Formal explanation of warranty terms and conditions for SMC products.

Switch Management

Connecting to the Switch

Describes various methods to establish management access to the switch.

Basic Configuration

Covers essential initial setup steps for the switch's operation.

Security

Details methods to secure the switch against unauthorized access.

Port Configuration

Manages individual network port settings like speed, duplex, and status.

Spanning Tree Protocol Configuration

Configures STP to prevent network loops and ensure optimal topology.

Configuring the Switch

Using the Web Interface

Provides an overview of the switch's graphical management interface.

Basic Configuration

Covers essential initial setup steps for the switch's operation.

Security

Details methods to secure the switch against unauthorized access.

Managing Firmware

Describes procedures for updating the switch's operating software.

VLAN Configuration

Enables network segmentation by grouping ports into virtual LANs.

Command Line Interface

Using the Command Line Interface

Overview of accessing and navigating the switch's Command Line Interface.

General Commands

Basic commands for CLI operation and system control.

System Management Commands

Commands for managing system settings, logs, and user accounts.

IP Commands

Commands for configuring IP addressing and network connectivity.

Interface Commands

Commands for configuring individual network port settings.

Troubleshooting

Troubleshooting Chart

A guide to diagnosing and resolving common connectivity and configuration issues.

Upgrading Firmware via the Serial Port

Glossary