(Continuous AFt
In this AF mode, the camera continues to focus while the
shutter button is pressed and held hall\_ ay down. This mode
is used when the subject is in motion.
• If tile wide AF area is selected, tile locus tiame swilches 1o
match tile position of the sub.iect. Tile frame ill locus turns red
and starts flashing.
• The buzzer will not sound when tile subject is ill tllctls,
Tomakeafineadjustmentin _ (DirectManualFocus)
(_) Select _ (Dir_:ctManual Focus) in AF mode.
@ Press the shutter button halI\_ay down to lock the fucus.
@ Turn the li)cusing ring to fine-tune the lbcus while pressing the shutter button hall\_ay down.
Shutter button
Focusinc '
(_) Press the shutter button fully down.
• Ollce yotl release yotlr l]llger frol/l tile shutler btltlon, the focus lock operalion starls aga]ll froln tile
beginning when you press tile s]ltluer btluon hallway down.
Sets up the flash mude and the flash compensation.
54
If Ihe buillqu flash is pulled up. the flash aulematically fires when the surruuudiugs are dark
/lhe defaull seltiug/. Yuu can iuteutiunally change Ihe flash mode.
(!) Display Ihe flash mode screen with Ihe function dial and Ihe Fn button (page 43).
Flash mode
Autoflash
_+-o.o
:func.4_:select • :e_ter
@ Display Ihe Flash mode screen _ilh • on the controller.
@ Select the desired mode with 411_ on the controller, Ihen press the center of Ihe conlroller.
To Next Page
Loading...
Need help?
General
