Sony DSR-200A User Manual

93
Additional information
AC power adaptor
Remove the battery pack from the AC
power adaptor. Then install the same
battery pack again.
When the CHARGE lamp flashes again
Install another battery pack.
When the CHARGE lamp flashes again
The problem is with the AC power adaptor.
Please contact your nearest Sony dealer in
connection with the problem.
When the CHARGE lamp does not flash
again
If the CHARGE lamp lights up and goes
out after a while, there is no problem.*
When the CHARGE lamp does not flash
again
If the CHARGE lamp lights up and goes
out after a while, the problem is with the
battery pack installed first.
When the CHARGE lamp flashes
Check through the following chart.
Symptom
The VTR/CAMERA or
CHARGE lamp does not light.
The CHARGE lamp flashes.
Corrective Actions
• Disconnect the power cord. After about 1 minute, reconnect
the power cord.
• See the following chart.
$
$
$
$
$
* If you use a battery pack which you have
just bought or which has been left unused
for a long time, the CHARGE lamp may
flash at the first charging. This does not
indicate a problem. Repeat again to charge
with the same battery pack.
Trouble check

Sony DSR-200A Specifications

Lens

zoom	10 x Zoom (f = 5.9 to 59 mm)
digital zoom	20 x
filter diameter	52 mm

Camera

image device	3 CCD 1/3-inch, Interline-Transfer Sensor
picture elements	768 (h) x 494 (v) (effective), 811 (h) x 508 (v) (total)
signal system	EIA standard, NTSC Color system

Power

power requirement	DC 7.2 V (Battery operation), DC 8.4 V (AC adaptor)
power consumption	11.6 W (during camera recording)
external DC input	4-pin for DK-715 cable

Operating Environment

operating temperature	0 C˚ to 40 C˚ (32 F˚ to 104 F˚)
storage temperature	-20 C˚ to 60 C˚ (-4 F˚ to 140 F˚)
viewfinder interface	8-pin connector

Dimensions

width	216 mm
height	237 mm
depth	474 mm

Weight and Dimensions

mass without tape and batteries	3.6 kg
mass with tape and batteries	4.7 kg
dimensions (w x h x d)	216 x 237 x 474 mm