Power Unit Mechanical: 1D-2
Service Instructions
Tappet Clearance Inspection
Z9J0111406028
Refer to “Tappet Clearance Inspection and Adjustment”
in Section 0B (Page 0B-8).
Ring Gear Cover Removal and Installation
Z9J0111406001
Removal
Prior to removing ring gear cover, disconnect
battery cables from battery.
1) Loosen the four bolts securing ring gear cover (1).
2) Remove the ring gear cover.
Installation
Installation is reverse order of removal.
Cylinder Head Cover Removal and Installation
Z9J0111406002
Removal
Before removing cylinder head cover, disconnect
battery cables from battery.
1) Remove both lower side covers.
Refer to “Lower Side Cover Removal and
Installation” in Section 2A (Page 2A-3).
2) Remove the two bolts securing fuel pump guard (1).
3) Loosen the clamp securing breather hose (2), then
remove the breather hose from cylinder head cover.
4) Disconnect ignition coil connectors (3).
Remove the bolts securing the ignition coils (4).
Remove all ignition coils and spark plugs.
5) Disconnect inlet hose (5) and outlet hose (6) from
low pressure fuel pump (7).
Remove bolts and low pressure fuel pump.
I9J011140078-01
I9J011140079-01
I9J011140080-01
I9J011140081-01
I9J011140082-01
To Next Page
Loading...
Need help?
General
