ENGINE 3-91
OIL JET
OIL JET (for the cylinder head) REMOVAL
• The oil jet (for the cylinder head) can be removed after remov-
ing the cylinder block.
NOTE:
Refer to the following pages for the details of each step.
Drain:
• Engine oil (!2-9)
Remove:
• Cylinder block (! 3-14)
• Oil jet (for the cylinder head)

1
OIL JET (for piston cooling and the transmission)
REMOVAL
• The oil jet (for piston cooling and the transmission) can be
removed after separating the crankcase.
Remove:
• Oil jet (for piston cooling)
• Oil jet (for the transmission)
INSPECTION
Make sure that the oil jets are not clogged. If they are clogged,
clean their oil passage using a wire of the proper size and com-
pressed air.
To Next Page
Loading...
Need help?
General
