FUEL AND LUBRICATION SYSTEM 4-5
FUEL PUMP
REMOVAL
• Remove the left frame cover. (9 5-3)
• Turn the fuel cock to “ON”
• Disconnect the fuel hoses 1, 2 and vacuum hose 3.
• Remove the fuel pump mounting bolts.
INSPECTION
!
Gasoline is very explosive. Extreme care must be taken.
• Disconnect the fuel hose 2, connect the suitable hose and
insert the free end of the hose into a receptacle.
Check the fuel flow when cranking the engine for few seconds
by pressing the starter button.
If the fuel flow is not found, check the fuel cock. (94-4)
If the fuel cock and hoses are not fault, replace the fuel pump.
REASSEMBLY
Carry out the assembly procedure in the reverse order of disas-
sembly.
• Install the clamp to the bolt A and tighten the bolts.
• Connect the fuel hoses 1, 2 and vacuum hose 3 securely.
FUEL HOSE ROUTING: 97-18
Fuel hose 1 (To fuel cock)
Fuel hose 2 (To carburetor)
Vacuum hose 3 (To intake pipe)
To Next Page
Loading...
Need help?
General
