ELECTRICAL SYSTEM 6-19
INSPECTION
IGNITION COIL PRIMARY PEAK VOLTAGE
• Remove the fuel tank. (!4-3)
• Remove the two spark plug caps.
• Connect new two spark plugs to the each spark plug cap and
ground them.
NOTE:
Be sure that all couplers and spark plugs are connected prop-
erly and the battery used is in fully-charged condition.
Inspect the No. 1 ignition coil primary peak voltage in the follow-
ing procedure.
• Connect the multi circuit tester with peak voltage adaptor as
follow.
No. 1 ignition coil: White terminal – Ground
(+ Probe) (- Probe)
NOTE:
Do not disconnect the ignition coil primary wire.
" 09900-25008: Multi circuit tester set
&
When using the multi circuit tester and peak volt adap-
tor, follow the instruction manual.
• Shift the transmission into the neutral and turn ignition switch
“ON”.
• Crank the engine a few seconds with starter motor by de-
pressing starter button and then check the ignition coil pri-
mary peak voltage.
• Repeat the above inspection a few times and measure the
highest ignition coil primary peak voltage.
' Tester knob indication: Voltage (
%%
%%
%)
# Ignition coil primary peak voltage: More than 250 V
.
Do not touch the tester probes and speak plugs to pre-
vent an electric shock while testing.
To Next Page
Loading...
Need help?
General
