5-8 CHASSIS
INSPECTION AND DISASSEMBLY
TIRE
For inspection of the tire: 92-16
FRONT AXLE
Measure the front axle runout using the dial gauge. If the runout
exceeds the limit, replace the front axle.
% 09900-20606: Dial gauge (1/100 mm)
09900-20701: Magnetic stand
09900-21304: V-block set (100 mm)
# Front axle shaft runnout:
Service Limit: 0.25 mm
WHEEL
Make sure that the wheel runout (axial and radial) does not ex-
ceed the service limit when checked as shown. An excessive
amount of runout is usually due to worn or loose wheel bearings
and can be corrected by replacing the bearings. If bearing re-
placement fails to reduce the runout, replace the wheel.
# Wheel runout:
Service Limit (axial and radial): 2.0 mm
SPOKE NIPPLE
Check to be sure that all nipples are tight, and retighten them as
necessary using a spoke nipple wrench.
% 09940-60113: Spoke nipple wrench
" Spoke nipple: 4.5 N
.
m (0.45 kgf
.
m)
To Next Page
Loading...
Need help?
General
