Suzuki VL125 Service Manual

3-58 ENGINE
• Install the clutch sleeve hub nut, and tighten it to the specified
torque using the special tool.
% 09920-53740: Clutch sleeve hub holder
" Clutch sleeve hub nut: 50 N
.
m (5.0 kgf
.
m)
• Bend the lock washer securely.
• Install the clutch drive plates and driven plates.
1 Clutch drive plate No. 2
2 Clutch drive plate No. 1 (×2)
3 Clutch driven plate (×3)
• Install the clutch plate spacer 4.
• Install the clutch release rack 5, bearing 6 and washer 7.
• Install the clutch pressure plate 8, clutch springs and clutch
spring mounting bolts.
• Hold the primary drive gear nut and tighten the clutch spring
mounting bolts in a crisscross pattern.
NOTE:
Make sure that the clutch pressure plate is installed correctly.
" Clutch spring mounting bolt: 10 N
.
m (1.0 kgf
.
m)
Inside
Outside

Suzuki VL125 Specifications

General

Displacement	124 cc
Ignition	Electronic ignition (CDI)
Starter	Electric
Transmission	5-speed constant mesh
Final Drive	Chain
Front Suspension	Telescopic, coil spring, oil damped
Rear Suspension	Swingarm, coil spring, oil damped
Rear Brake	Drum
Overall Length	2, 080 mm
Overall Width	760 mm
Ground Clearance	150 mm
Fuel System	Carburetor
Front Brake	Single disc
Front Tire	90/90-18
Seat Height	735mm