Tektronix DPO71254C Printable Help

Learn how to trigger on a bus.
Set up a MIPI DSI-1 serial bus
NOTE. MIPI DSI-1 serial bus setup is available only on instruments with the SR-DPHY option.
From the Bus Setup window in the Config tab, select a bus from the Bus list and then select the MIPI DSI-1 Serial bus type.
NOTE. The Components for the MIPI DSI-1 bus standard are set by the instrument.
For information on the controls, click the buttons.
■
Bus List
■
Display & Clear
■
Label
■
Position
■
Serial Input
■
Lanes
■
Channel Type
■
Serial Threshold
To use
■
To set the channel type, click the Channel Type entry box and select from the drop-down list.
■
To change the input for a component, click the Input and select a channel from the cascading lists.
■
To change the voltage threshold level, click the Threshold entry box and use the keypad to enter a value or use the
multipurpose knobs to select a voltage level. Set the threshold on the low power portion of the waveform.
Behavior
The instrument changes the components, voltage threshold levels, polarity, data bits, parity, and bit rate, and uses those to
decode the selected MIPI DSI-1 bus.
What do you want to do next?
Learn more about bus setups.
Bus setups
120 DPO70000SX, MSO/DPO70000DX, MSO/DPO70000C, DPO7000C, and MSO/DPO5000B Series

Tektronix DPO71254C Specifications

General

Brand	Tektronix
Model	DPO71254C
Category	Test Equipment
Language	English