Tektronix DPO71254C Printable Help

Learn about Custom Serial Bus Setup
Set up parallel search parameters
After setting up a parallel bus, go to the Analyze menu, select Search, and then select the Bus trigger type; then open the
Configure tab.
Overview
Use the controls to set up the Parallel Bus parameters.
To use
For information on the controls, click the buttons.
■
Type
■
Source
■
Copy Settings
■
Search Parameters
■
Search / Mark Controls
Behavior
Clicking an entry in the Type column activates the individual search controls, similar to the one shown above. These controls vary
depending on the search Type. Setting the search conditions is similar to setting the parameters for an Event Trigger.
NOTE. No information will be displayed in this window until you specify at least one search Type in the Search Select Control
Window.
Analyzing waveforms
362 DPO70000SX, MSO/DPO70000DX, MSO/DPO70000C, DPO7000C, and MSO/DPO5000B Series

Tektronix DPO71254C Specifications

General

Brand	Tektronix
Model	DPO71254C
Category	Test Equipment
Language	English