Tektronix DPO7254C Printable Help

Set up 8B10B search parameters
After setting up an 8B10B bus, go to the Analyze menu, select Search, and then select the Bus trigger type; then open the
Configure tab.
Overview
Use the controls to set up the 8B10B Bus parameters.
To use
For information on the controls, click the buttons.
■
Type
■
Source
■
Copy Settings
■
Search Parameters
■
Search / Mark Controls
Behavior
Clicking an entry in the Type column activates the individual search controls, similar to the one shown above. These controls vary
depending on the search Type. Setting the search conditions is similar to setting the parameters for an Event Trigger.
NOTE. No information will be displayed in this window until you specify at least one search Type in the Search Select Control
Window.
To use
■
Click the Source box and select the bus number or name from the window. Bus Search Selection List
■
Select the type of bus cycle or activity to search for from the Search For drop-down list.
Analyzing waveforms
314 DPO70000SX, MSO/DPO70000DX, MSO/DPO70000C, DPO7000C, and MSO/DPO5000B Series

Tektronix DPO7254C Specifications

General

Bandwidth	2.5 GHz
Channels	4
Display Size	12.1 inches
Input Coupling	AC, DC, GND
Vertical Sensitivity	1 mV/div to 10 V/div
Power Supply	100-240 VAC, 50/60 Hz
Sample Rate	40 GS/s
Record Length	50 Mpoints
Vertical Resolution	8-bit
Display Type	XGA LCD
Trigger Modes	Edge, Pulse, Runt, Timeout, Logic
Interface	USB, GPIB, Ethernet
Input Impedance	1 MΩ ±1% with 13 pF ±2 pF; 50 Ω ±1%
Input Voltage Range	1 MΩ: 300 Vrms, 50 Ω: 5 Vrms