Field or control Description
MISO Input Select the channel source and threshold level for the Master In Slave/Out signal.
Set the Polarity to use Active High or Active Low logic for the signal.
Word Size Enter the word size, in bits. Common word sizes are 8, 16, and 32.
Bit Order Set to most significant bit first (MS First) or least significant bit first (LS First).
Idle Time (Framing = ) Set the idle frame time.
A
vailable when Framing = Idle.
Display Format Sets the waveform view to show just the decoded bus information, or the decoded bus and the logical
views of each constituent signal.
Decode Format Sets the decode format used to display the bus information. Formats are Hex and Binary.
Other bus types
Serial bus types, such as CAN, LIN, Ethernet, and so on, are available as purchasable options. Once purchased and installed, the new bus
types are shown in the Bus T
ype menu. The serial bus options also add corresponding bus trigger capabilities to the Trigger menu.
Use the following links to access information on specific Bus configuration menus.
Parallel Bus configuration menu on page 127
I2C serial bus configuration menu on page 123
SPI serial bus configuration menu on page 131
RS-232 serial bus menu on page 129
CAN serial bus configuration menu on page 120
LIN serial bus configuration menu on page 124
FlexRay serial bus configuration menu on page 122
Audio serial bus configuration menu on page 118
USB serial bus configuration menu on page 132
MIL-STD-1553 serial bus menu on page 126
ARINC429 serial bus menu on page 117
See also
Bus Trigger configuration on page 199
Bus Search configuration menus on page 135
USB serial bus configuration menu
Use the USB bus menu (optional) to set up and display an USB 2.0 (Universal Serial Bus) waveform.
To set up a USB serial bus:
Menus and dialog boxes
3 Series Mixed Domain Oscilloscope Printable Help 132
To Next Page
Loading...
Need help?
General
