Field or control Description
Channel Sets the audio channel on which to trigger.
A
vailable when Trigger On = Data and the Audio bus is TDM.
Trigger When Sets the trigger when condition for the specified data pattern.
When set to Inside Range or Outside Range, fields are displayed to set a high and low boundary
pattern for the specified trigger type.
Tap the Binary, Hex, or Decimal field and use the A and B knobs to select and change the values. Or
double-tap on the field and use the virtual keypad to enter values.
Available when Trigger On = Data.
Data Sets the data pattern on which to trigger. Use in conjunction with the Trigger When field to specify the
exact trigger condition.
Tap the Binary, Hex, or Decimal field and use the A and B knobs to select and change the values. Or
double-tap on the field and use the virtual keypad to enter values. See Binary, decimal, hex, and octal
virtual keypads on page 228.
Available when Trigger When ≠Inside Range or Outside Range.
Data High Sets the data high pattern which, if exceeded, will cause a trigger.
Tap the Binary, Hex, or Decimal field and use the A and B knobs to select and change the values. Or
double-tap on the field and use the virtual keypad to enter values.
Available when Trigger When = Inside Range or Outside Range.
Data Low Sets the data low pattern which, if exceeded, will cause a trigger.
Tap the Binary, Hex, or Decimal field and use the A and B knobs to select and change the values. Or
double-tap on the field and use the virtual keypad to enter values.
Available when Trigger When = Inside Range or Outside Range.
A, B knob controls Use the A knob to select (highlight) the digit(s) to change.
Use the B knob to change the value of the digit(s).
Mode & Holdoff
Trigger Mode determines how the instrument behaves in the absence or presence of a trigger event.
Holdoff sets the amount of time the oscilloscope waits after a trigger event before detecting and
triggering on the next trigger event.
For additional information on Trigger Mode, Holdoff, forcing a trigger, and the Trigger Frequency
Counter see Mode and Holdoff panel on page 226.
Act On Trigger
Set the actions the instrument takes when a trigger event occurs.
For additional information on the Act On Trigger panel see Act On Trigger configuration
menu on page 227.
CAN serial bus trigger settings panel
Use the CAN bus menu (optional) to set up and display a CAN (Controller Area Network) serial bus waveform.
Note: Requires option SRAUT
O.
Menus and dialog boxes
3 Series Mixed Domain Oscilloscope Printable Help 202
To Next Page
Loading...
Need help?
General
