Field or control Description
Service Name The instrument service name is displayed. To change the name, double-tap and enter a name in the
virtual keyboard.
Gateway IP Address Use the multipurpose knobs to enter the address. Use the A knob to select the digit, and the B knob to
change the value.
Only available to edit when Network Address = Manual
DNS IP Address Use the multipurpose knobs to enter the address. Use the A knob to select the digit, and the B knob to
change the value.
Only available to edit when Network Address = Manual
MAC Address A readout of the instrument MAC Address. This field is not editable.
e*Scope HTTP Port A readout of the instrument e*Scope HTTP port number. This field is not editable.
Test Connection Test the connection. If the connection test is successful, then OK is displayed. If the test is
unsuccessful, then No Response is displayed.
LAN Reset Display the LAN Reset configuration menu (Utility > I O menu) on page 186.
Apply Changes Apply changes made on this panel to the instrument.
Note: No changes are made to instrument settings until you tap the Apply Changes button.
USB Device Port fields and controls
Use the USB Device Port panel to enable or disable the USB port and set the GPIB T
alk/Listen address. Use USB ports to connect a USB
memory device, keyboard, or for direct PC control of the oscilloscope using USBTMC protocol.
Field or control Description
USB Device Port Toggles the USB device port On and Off.
USBTMC Configuration Displays the USBTMC configuration information.
GPIB Talk/Listen Address Enter the address using the virtual keypad.
Socket Server panel fields or controls
Use the following socket server settings to set up and use a socket server between your oscilloscope and a remote terminal or computer
.
Field or control Description
Socket Server Toggles the socket server On or Off.
Protocol Tap to select a protocol, either None or Terminal.
A communication session run by a user at a keyboard typically uses a terminal protocol. An automated
session might handle its own communications without such protocol from the oscilloscope.
Port Enter the port number using the multipurpose knob or virtual keypad.
AUX Out panel fields and controls
Use the following settings to select the signal that is output on the rear-panel AUX Out signal connector
.
Menus and dialog boxes
3 Series Mixed Domain Oscilloscope Printable Help 185
To Next Page
Loading...
Need help?
General
