Tektronix MDO4054-3 User Manual

Save and Recall I
nformation
2. Push R1, R2, R3
,orR4.
(R1) |
(On)
(R2) |
(Off)
(R3) |
(Off)
(R4) |
(Off)
If you push the side-menu Ref Details,you
can read wheth
er the reference holds analog
waveform or RF trace information.
Removing a reference waveform from the display. To remove a reference waveform from the display:
1. Push Ref R.
2. Push the R1, R2, R3,orR4 lower-bezel
button to remove the reference waveform or
trace from the display.
(R1) |
(On)
(R2) |
(Off)
(R3) |
(Off)
(R4) |
(Off)
The reference waveform is still in nonvolatile
memory and can be displayed again with
another push of the button.
NOTE. 10 M and 20 M reference waveforms
are volatile and not saved when the oscilloscope
power is turned off. To keep these waveforms,
save them to external storage.
Saving and Recalling Setups
Setup information includes acquisition information, such as vertical, horizontal, tri gger, cursor, and measurement information.
It does not include communications information, such as GPIB addresses. To save the setup information:
1. Push Save / Recall Menu .
2. Push Save Setup or Recall Setup from the
lower-bezel menu.
Save
Screen
Image
Save
Waveform
Save
Setup
Recall
Waveform
Recall
Setup
Assign
Sav
e|to
Setup
File
Utilities
MDO4000 Series Oscilloscopes User Manual 167

Tektronix MDO4054-3 Specifications

General

Brand	Tektronix
Model	MDO4054-3
Category	Test Equipment
Language	English