Installation
CAUTION. To ensure proper cooling, keep the sides and rear of the instrument clear of obstructions. Ventilation clearance
should be at least 51 mm (2 in) on the left side, when looking at the front of the instrument, and on the rear of the instrument
Find more information on MDO4000 Series oscilloscope specifications in Appendix A. (See page 180, Appendix A:
MDO4000 Specification
s.).
Find information on T
PP0500/TPP1000 probes in A ppendix B. (See page 184, Appendix B: TPP0500 and TPP1000
500 MHz and 1 GHz 10X Passive Probes Information.)
Find information on P6616 probes in Appendix C. (See page 191, Appendix C: P6616 General-Purpose Logic Probe
Information.)
Cleaning
Inspect the oscilloscope and probes as often as operating conditions require. To clean the exterior surface, perform the
following steps:
1. Remove loose dust on the outside of the oscilloscope and probes with a lint-free cloth. Use care to avoid scratching
the display.
2. Use a soft cloth dampened with water to clean the oscilloscope. Use an aqueous solution of 75% isopropyl alcohol
for more efficient cleaning.
CAUTION. Avoid getting moisture inside the unit during external cleaning. Use only enough cleaning solution to dampen
the cloth or swab.
CAUTION. To avoid damage to the surface of the oscilloscope or probes, do not use any abrasive or c hemical cleaning
agents.
Operating Positions
Use the handle and front flip f
eet to place the oscilloscope in a convenient operating position. When the feet are extended,
always have the handle in a down position.
MDO4000 Series Oscilloscopes User Manual 7
To Next Page
Loading...
Need help?
General
