Tektronix PS 5010 User Manual

LIST OF ILLUSTRATIONS (cont)
Fig.
No.
5-1
5-2
5-3
5-4
5-5
5-6
5-7
5-8
6- 1
6-2
6-3
6-4
6-5
6-6
6-7
6-8
Page
Connections for rear interface load
effect check. Dvm must be connected
............
to same point as sense lines.
5-6
Test fixture for load transient recovery.
....
5-7
Load transient recovery waveforms
.......
5-7
Test setup for checking load effect in
..............
the constant current mode
5-1 0
Connections for rear interface logic
supply load effect check. Dvm must
be connected to same point as sense
.................................
lines 5-13
Adjustment interactions. If the inter-
secting square is darkened the ad-
......................
justments interact 5-1 6
.........
Test setup for Max I Adj., Step 2
5-17
Locations of
Sl6OO and Sl5OO on rear
.........................
of instrument. 5-1 9
.............
Address switch and jumpers
Orientation and disassembly of
....................
multipin connectors
Bottom view of instrument showing
..................
screws holding boards
.................
Interface board removal
CPU clock waveform timing
tolerances. This waveform is TTL
compatible.
...........................
Assignments for rightmost connector
........
as viewed from rear of instrument
Assignments for leftmost connector
........
as viewed from rear of instrument
Assignments for GPlB connector as
viewed from rear of instrument
...........
Fig.
No.
NOTE
The following illustrations are located in the diagrams
section at the rear of this manual.
GPlB address switch and buffer test
Kernel test-CPU address lines and
address coding
Kernel test-ROM verification
Firmware signature analysis
addressldata bus
Firmware signature analysis-
addressable latches
Firmware signature analysis-GPIB
chip test (U1001)
Firmware signature analysis-
keyboard encoder
(U 1 421 )
Firmware signature analysis-logic
supply shift registers
Floating supply board (A14) adjustments
Adjustments access through bottom
of instrument
CPU board (A12)
CPU board (A12)
CPU board (A1 2)
CPU board (A1 2)
CPU board (A1 2)
Front panel board (A1
0)
Floating supply filter board (A1 3)
Logic supply board (A1
4)
Logic supply filter board (A1 3)
Floating supply board (A1 4)
Floating supply board (A1 4)
Floating supply board (A1 4)
Interconnect board
(A1 1
)
REV MAR 1986

Tektronix PS 5010 Specifications

General

Brand	Tektronix
Model	PS 5010
Category	Power Supply
Language	English