TCP303 and TCP404XL Performance Verification
TCPA300/400 Amplifiers and TCP300/400 Series Current Probes Instruction Manual
5-41
Table 5- 22: Bandwidth test for the TCP303
TEKPROBE cable BNC cable
Probe Range
Oscilloscope
vertical Gain
TCPA300
output
Oscilloscope
vertical gain
TCPA300
output
M1 @
3 MHz ref
freq
M2 @
warranted BW
freq (15 MHz)
Calcula-
tion
1
TCP303 5A/V 10 mA/div ~60 mA p--p 2mV/div ~12 mV p--p
1
Use the formula in step 9 below.
9. The probe meets the bandwidth specification if the ratio of the signal
amplitude at the warranted bandwidth is at least 70.7% of the signal
amplitude at 3 MHz. Using the following calculation, verify probe band-
width:
Ꮛ
M
2
M
1
Ꮠ
> 0.707
10. Record the results on the test record.
Bandwidth (TCP404XL)
The bandwidth of the probe is derived as a function of the probe rise time. The
rise time (t
r
) is measured in nanoseconds between the 10% and 90% points of the
leading edge of the pulse. (Refer to the procedure beginning on page 5--36). To
calculate the probe bandwidth, use the following formula:
Ꮛ
0.35
t
r
Ꮠ
= Bandwidth
For example, a rise time of 175 ns would result in the following solution:
Ꮛ
0.35
175 × 10
−9
seconds
Ꮠ
= 2.0 × 10
6
Hertz
1. Record the results on the test record.
This completes the performance verification for the TCP303 and TCP 404XL
probes.
If the TCP303 or TCP404XL probes fail any of the verification tests, refer to the
Adjustments section for servicing information.
To Next Page
Loading...
Need help?
General
