TCPA300/400 Amplifiers and TCP300/400 Series Current Probes Instruction Manual
xv
Preface
This Instruction Manual supports the operation and basic maintenance of the
TCPA300 and TCPA400 Current Probe Amplifiers, and the TCP300/400 Series
AC/DC current probes that mate with the amplifiers. The current probes covered
in this manual are listed below:
H TCP312 (30 amps, 100 MHz, compatible with TCPA300)
H TCP305 (50 amps, 50 MHz, compatible with TCPA300)
H TCP303 (150 amps, 15 MHz, compatible with TCPA300)
H TCP404XL (500 amps*, 2 MHz, compatible with TCPA400)
*750 amps DC derated with duty cycle
If you are not familiar with these products, please refer to the Getting Started and
Operating Basics chapters of this manual for basic operating information.
If you are an advanced user, the Reference section contains information on
advanced applications as well as user diagnostic and troubleshooting informa-
tion.
The Performance Verification and Adjustment Procedure sections support the
qualification and calibration of the probes when used with either amplifier.
The Maintenance section supports the routine maintenance and repair of
mechanical parts associated with the amplifiers.
The Glossary and Index are provided as quick reference locators for important
information.
Manual Conventions
The term “amplifier” is used to refer to either the TC PA300 or TCPA 400 when
referring to common attributes. If a subject is unique to either amplifier, the
amplifier will be referred to directly by model.
The terms “current probe” and “probe” are used to refer to any of the
TCP300/400 Series current probes when referring to common attributes. If a
subject is unique to a particular probe, the probe will be referred to directly by
model.
To Next Page
Loading...
Need help?
General
