In power-on state, press and hold the button with a spike for 8s and release it, and the
device will be restored to factory state.
USB3.0 Connects USB devices such as USB disks, mobile hard disks, and printers.
Intranet port that connects devices such as switches and computers.
WAN3/LAN1,
WAN2/LAN2,
WAN1/LAN3
Multiplexing for Intranet and Extranet ports.
WAN3/LAN1 and WAN2/LAN are Intranet (LAN) ports by default.
WAN1/LAN3 is an Extranet (WAN) port by default.
The router enables 2 WAN ports by default. If you need to modify the number of WAN
ports, please go to Network > Internet Setup and select the number of WAN ports.
Extranet port that connects Extranet cables. Extranet cables may be network cables
from ADSL, fiber, and cable television cats, or broadband network cables directly
provided by the broadband operator.
1.3.2 Rear Panel
Power port: Connects the power cord. Please use the supporting power cord in the product packing box for
connection.
Power switch: After the power cord of the device is connected, press this button for power supply to the
device.
To Next Page
Loading...
Need help?
General
