Using the ADS1298ECG-FE Software
www.ti.com
10
SBAU171D–May 2010–Revised January 2016
Submit Documentation Feedback
Copyright © 2010–2016, Texas Instruments Incorporated
ADS1298ECG-FE/ADS1198ECG-FE
The CONTINUOUS control starts a repeated acquisition process. This function acquires the requested
samples and repeats the data acquisition until the button is turned off. Within a single acquisition cycle,
the points will be contiguous, but from acquisition to acquisition, there may be points missing.
The Analysis Data input referred checkbox changes the displayed data that is read from the ADC.
Checking the box displays the data input referred, while not checking displays the data as converted.
The Show/Poll Lead Off Status displays a window (see Figure 7) that shows the status of the Lead-Off
status registers, LOFF STATP and LOFF STATN, of the ADS1298. When the lead for the channel is
disconnected, the corresponding channel LED changes from green to red.
Figure 7. Lead-Off Status Registers Display Window
3.3 About Tab
The About tab provides software information to the user. Important safety warning, restrictions, and
disclaimers for the software and hardware are shown and should be followed during the evaluation of this
product. Additional indicators are present to provide device information (Device ID and Rev) and software
information (Firmware Version). The About tab should be the first screen displayed at startup (see
Figure 3).
To Next Page
Loading...
Need help?
General
