8.Install Disc
104 Installing the printer drivers by using the individual installers
Confirm or change the SNMP settings
[SNMP Settings]
If the SNMP settings are not the same in your TOSHIBA MFP and the [SNMP Settings] dialog box, you cannot find your
TOSHIBA MFP. Verify the correct SNMP settings on the [SNMP Settings] dialog box and change the settings, if needed.
Ask the administrator for details on the SNMP settings configured for your TOSHIBA MFP.
When SNMP V1 and V2 are used
1. Select [V1/V2] if a community name other than “private” (default) is set for the SNMP community name for your
TOSHIBA MFP.
2. Change the SNMP community name.
3. Click [OK].
When you change the SNMP community name, see the following page:
When SNMP V3 is used
1. Select [V3].
2. When a user ID file is used for authentication, click [Browse] to specify the file.
When user authentication information is used for authentication, click [User Name/Password] to enter the
necessary information.
Consult the administrator for preliminary advice on how to authenticate users.
When you change the SNMP settings, see the following page:
3. Click [OK].
* When SNMP V1, V2, and V3 are configured for your TOSHIBA MFP, select [V1/V2/V3] and carry out both of the above settings.
To Next Page
Loading...
Need help?
General
