8.Install Disc
Installing the printer drivers by using the individual installers 99
Install Disc
Raw TCP/LPR printing
Configure the Raw TCP/LPR port as described in the following procedure.
Confirm the following before starting the configuration:
This equipment is connected to the network and turned on.
The TCP/IP setting is correct on this equipment and your computer.
Searching your TOSHIBA MFP automatically
This equipment is automatically discovered over the network. Then you can install the printer driver so as to configure
the Raw TCP/LPR port.
If this equipment is not discovered over the network after the installation is started, a dialog box indicating this
appears. Follow the procedure below to continue the configuration.
To search this equipment over the network again, click [Retry].
Click [SNMP Settings] and confirm whether the SNMP settings specified in the [SNMP Settings] dialog box are
correct.
When you confirm or change the SNMP settings in order to find your TOSHIBA MFP, see the following section.
P.104 “Confirm or change the SNMP settings”
When you set the conditions to search the MFPs on the network in the [Manual Selection] dialog box, see the
following section.
P.105 “Narrowing Down Search Conditions”
If your TOSHIBA MFP is not found, refer to the following page:
P.101 “If your TOSHIBA MFP is not found”
If you know the IP address of this equipment, you can specify a printer port with the direct entry from the keyboard.
In step 6, enter a network path shown below in [Printer port].
\\IP_<IP address> or \\<IP address>
6
A list for the discovered printers is displayed. Then select this equipment on the list and then
click [Install].
Searching may take a while depending on the Windows OS or network environment.
To Next Page
Loading...
Need help?
General
