2.SETTING ITEMS (ADMIN)
Setting Network Functions 159
2 SETTING ITEMS (ADMIN)
4
Continue to another network setting if required, then press [APPLY NOW].
“NETWORK INITIALIZING” is displayed at the lower left of the screen and this equipment starts initializing the
network interface card to apply the changes. This message disappears after it is finished.
Setting the LDAP services and the filtering functions
This function allows this equipment to access the LDAP directory service. The equipment can search the LDAP server for
contacts to specify recipients for Internet Faxes, fax transmissions, and Scan to E-mail jobs.
In this setting menu, you can also select whether to use the IP/MAC address filtering functions.
If the LDAP network service is enabled, you can register the LDAP directory service, and then this equipment can
search for contacts in the LDAP server. To add the LDAP directory service, you must operate using TopAccess. For
more information about registering the directory service, refer to the TopAccess Guide “Chapter 8: [Administration]
Tab Page”.
When the LDAP network service is disabled, it is not possible to use the user’s e-mail address as “From Address” from
the LDAP server during the User Authentication for Scan to Email.
1
Press [NETWORK] in the ADMIN menu (1/2).
The NETWORK menu is displayed.
To display the ADMIN menu, see the following page:
P.75 “Entering Admin Menu”
To Next Page
Loading...
Need help?
General
